G5V-1 Low Signal Relay - OMRON - Americas
Product Details Portlet
G5V-1 Low Signal Relay
Ultra-miniature, Highly Sensitive SPDT Relay for Signal Circuits 3
- Ultra-miniature at 12.5×7.5×10 mm (L× W× H).
- Wide switching power of 1 mA to 1 A.
- High sensitivity: 150 mW nominal coil power consumption.
- Fully-sealed construction offering environment resistance.
- Conforms to FCC Part 68 requirements for coil to contacts.
(1,500 V, 10 × 160 νs)
- Models for ambient temperatures up to 90°C added to series.
|Contact form||Terminal Shape||Model||Rated coil voltage||Minimum packing unit|
|G5V-1||3 VDC||25 pcs/tube|
|Note:||When ordering, add the rated coil voltage to the model number.|
|However, the notation of the coil voltage on the product case as well as on the packing will be marked as □□ VDC.|
|NOTE:||The values here are initial values.|
|1.||Measured with 10 mA at 1 VDC with a voltage drop method.|
|2.||Measured with a 500 VDC megohmmeter between coil and contacts and a 250 VDC megohmmeter between contacts with the same polarity applied to the same parts as those used for checking the dielectric strength.|
|3.||This value was measured at a switching frequency of 120 operations/min and the criterion of contact resistance is 100Ω.|
This value may vary depending on the switching frequency and operating environment. Always double-check relay suitability under actual operating conditions.
|PCB Mounting Holes|
●Long-term Continuously ON Contacts
Using the Relay in a circuit where the Relay will be ON continu- ously for long periods (without switching) can lead to unstable contacts, because the heat generated by the coil itself will affect the insulation, causing a film to develop on the contact surfaces. Be sure to use a fail-safe circuit design that provides protection against contact failure or coil burnout.
When washing the product after soldering the Relay to a PCB, use a water-based solvent or alcohol-based solvent, and keep the solvent temperature to less than 40℃. Do not put the Relay in a cold cleaning bath immediately after soldering.